联系人:
陈生/林生
联系电话:
0755-33062282/33062283
点击这里给我发消息
点击这里给我发消息
维库旺铺
首页 | 公司介绍 | 公司动态 | 产品展示 | 库存查询 | 技术资料 | 联系我们 | 客户留言 | 在线订购

EMIC31B104SANC

暂无图片
EMIC31B104SANC资料
EMIC31B104SANC
PDF Download
 
File Size : 116 KB
Manufacturer: FUJI
Description: ...Application areas include transducer amplifiers, DC gain blocks and all the conventional op-amp circuits which now can be more asily implemented in single power supply
NOTES:   1. For a loaded output the measurements are observed after an RC filter consisting of a 1 kΩ resistor and a 0.01 µF capacitor to ground.   2. These limits define the range of operation for which the part will meet specification.   3. Within the supply range of 4.75 and 5.25 volts, the device operates as a fully calibrated linear accelerometer. Beyond these supply limits   the device may operate as a linear device but is not guaranteed to be in calibration.   4. The device can measure both + and acceleration. With no input acceleration the output is at midsupply. For positive acceleration the output   will increase above VDD/2 and for negative acceleration the output will decrease below VDD/2.   5. The device is calibrated at 20g.   6. At clock frequency70 kHz.   7. The digital input pin has an internal pullCdown current source to prevent inadvertent self test initiation due to external board level leakages.   8. Time for the output to reach 90% of its final value after a selfCtest is initiated.   9. Time for amplifiers to recover after an acceleration signal causing them to saturate.  10. Preserves phase margin (60) to guarantee output amplifier stability.  11. A measure of the devices ability to reject an acceleration applied 90 from the true axis of sensitivity.  12. The Status pin output is not valid following powerCup until at least one rising edge has been applied to the selfCtest pin. The Status pin is   high whenever the selfCtest input is high.  13. The Status pin output latches high if a Low Voltage Detection or Clock Frequency failure occurs, or the EPROM parity changes to odd. The   Status pin can be reset by a rising edge on selfCtest, unless a fault condition continues to exist.
 
相关型号
◆ EM1781
◆ EM6681
◆ EM6781
◆ EMB4
◆ EMB9T2R
◆ EMC2DXV5T1
◆ EMC3DXV5T1
◆ EMC4
◆ EMC5
◆ EMC5DXV5T1
  1PCS 100PCS 1K 10K  
价 格  
 
 
型 号:EMIC31B104SANC
厂 家:
封 装:
批 号:
数 量:190000
说 明:
 
 
运  费:
所在地:
新旧程度:
 
 
留言/订购
 
所需型号 厂家 封装 批号 数量*
 
留言
 
 
联系人/公司:
联系电话:
EMail:
 
 
 
 
联系我们:
联系人:陈生/林生
电 话:0755-33062282/33062283
手 机:13410347009
QQ:381509191,495099505
MSN:eson_ic@hotmail.com
传 真:0755-33062281
EMail:taitongda@126.com
公司地址: 深圳市福田区振华路赛格高科德电子市场22901室
订购须知: